As the topic says?...anyone done this?..I got a set of free CPC cat weights.
Cat weights in Axys primary
- Thread starter Volvokvaloya
- Start date
We have tried cat weights. They pull hard and load the motor. Problem we had was getting engagement under control.
Engagement trouble beacuse the belt to sheave clearance?
No, sir. We had adjusted for that. The tuck under of the weight, caused the issue.
Ok i see,thanks trs
Yes, for the change in pin height and wide roller.
From my understanding the new 2018+ cat primary setup the belt to sheave is not determined by the weight, it floats around a bit before contacting the rollers. So really the profile might be good but it doesnt have the proper "shelf" in the heel area to work in a polaris clutch?
Problem with a small pearl. It will eat into where the weights seat in the moveable. First generation RXL clutches had a set screw located there(moveable) to adjust weight tuck under. That may work.
Last edited:
Similar threads
