D
Sled ran fine last ride with a little bog on bottom end at the end of day.
Went to load for the big weekend but when I started it, only ran on PTO side so i changed plugs, check spark, and went through the carbs all looked fine. Took out in the field and no luck. So for fun I took off the PTO side plug cap and it started. It ran a little worse than the other but warmed up so I put the cap back on the PTO side then mag side stopped again. any suggestions? Missed the big ride on my sled, have to barrow one.
update 2/28
i have put in different motor and have swapped coil-plug caps and fuel pump still run's on one cylinder at a time. You can put hand over PTO side carb and the mag side will start to work but as soon as you take hand off the mag side stops again.
I tried to put the mpem on from the spare sled but it will not start at all. I have put the cowling with the dess cord and the cord that matches the mpem with no luck.
Went to load for the big weekend but when I started it, only ran on PTO side so i changed plugs, check spark, and went through the carbs all looked fine. Took out in the field and no luck. So for fun I took off the PTO side plug cap and it started. It ran a little worse than the other but warmed up so I put the cap back on the PTO side then mag side stopped again. any suggestions? Missed the big ride on my sled, have to barrow one.
update 2/28
i have put in different motor and have swapped coil-plug caps and fuel pump still run's on one cylinder at a time. You can put hand over PTO side carb and the mag side will start to work but as soon as you take hand off the mag side stops again.
I tried to put the mpem on from the spare sled but it will not start at all. I have put the cowling with the dess cord and the cord that matches the mpem with no luck.
Last edited: