Pto side driveshaft bearing removal?

garett87 · Sep 18, 2013

So I'm changing my switchback assault drivers from 2.52 to 2.86 avid drivers. Wondering if its better to press each driver on from the outside of the shaft on both sides instead of both from one side? If so, how do I remove the pto side bearing to slide the new driver on? I'm assuming there is an internal snap ring under the bearing, and I just use a puller to pop the bearing off?
Thanks Garett

LoudHandle · Sep 18, 2013

That bearing is press fit. A puller will get it off. Both drivers go on from the smaller tapered end.

garett87 · Sep 18, 2013

Ok so since the smaller tapered end is on my mag side I will just leave that bearing alone. Thanks

Search

Pto side driveshaft bearing removal?

garett87

Member

LoudHandle

Well-known member

garett87

Member

Similar threads