UPGRADED AXYS Rear Skid Bushings (rush, switchback, IGX Assault)

I have been working on these over the summer and I now have finally received the finished product!!!

-Issue I noticed: the rear mounting points where the rails mount to the rear crank arm are very loose. The stock bushings can move from side to side a lot. I thought this was odd having only had conventional suspension in my past mounted inside the tunnel they never had this much side to side movement. If you look closely at some sleds with more miles the black arm connected to the rail starts to wear into the steel inner bushing. First I thought it was just the rear mounting points but noticed the front mounting points in the tunnel use the same bushings as in the rear.

-My solution: instead of the bushing just being a sleeve I have added a flange added on the one end to take the side thrust load of the skid shifting side to side.


Here are a couple vids of the issue.
This is my sled:
https://www.youtube.com/watch?v=QNRJz_TOyCs

This is a brand new sled at a dealership. Granted it has like 8 mi on it; its still new:
https://www.youtube.com/watch?v=34h8GHo0-r4


Here is a vid of the side to side movement after the install of my bushings. Notice there is still a slight amount of side to side movement to ensure things will pivot more smootherlerly.
https://www.youtube.com/watch?v=4D-PDz6_A7w



I will be selling these in sets of 4.
-For the Rush style rear suspension two bushings replace the two rear position bushings and the other two are used where the front torque arms mounts to the tunnel. -Flange goes towards the inside of the sled in both locations.

-For the new assaults the bushings go in the front and rear position of the front torque arm. So upper and lower torque arm mounts.


Feel free to PM me or call/txt me to purchase a set of 4 for $60.

612 205 5324

Thanks

Kent

mountainhorse said:

For the AXYS-Rush based Switch Back ProX like this... Correct?

.

Click to expand...

any rush style axys pro x switchback rush
also should fit/replace the front torque arm bushings in the new IGX rear skid of the assault. havent tried them in that sled but if they designed it like the others there is probably a ton of slop.

ALL OUT OF BUSHINGS AT THE MOMENT.
PLEASE FEEL FREE TO EXPRESS INTEREST HERE AS IM TRYING TO DECIDE TO MAKE ANOTHER RUN OR NOT!

thank

kent

so i got enough interest to make another run of bushings.

i currently have 11 sets left.

pm me here or call or txt me @ 612 205 5324

kent

i am having another batch of these bushings produced. not 100% sure when they will be done but i will keep everyone in the loop.
feel free to pm me or just call txt me @ 612 205 5324

i have made another batch of these bushings for this season.
if you are interested reach out via txt or call the cell number listed above or pm me here!

i have made another urn of these bushings this season if anyone is interested.