2018 YZ450F mods needed?

Nonstop said:

Sorry it’s sideways

Click to expand...

•Added Garmin Montana .
•Seat concepts which I feel is not as near as comfortable as the fisher that I have rode on a different bike , as my tailbone was sore after 2 days riding ,and using padded bike shorts. But Stock seat is basically a 2 by 4 wrapped in razor wire
•Trail Tech temp plumbed into thermostat which registers much lower than the factory temp (Monitered from bikes Bluetooth App). So jury still out till i figure what proper operating temp will be.
•CR racing Intake which seems to work finebut is brutally loud
•P3 Guards (took a little minor mod to install)
•Forks done at RMR
•Cyclops light
•Modified existing Nytro tarp for Hauling on the sleddeck.
•Raze (tall)Pastrana bars with powermadd riser. Heated bars work great..
•Pst engine Blanket
With the tall bars AND riser had to do alot of cable re-routing.
•Pelican case with my Stihl saw





Sent from my iPhone using Tapatalk

800tundra said:

Also unplugged\removed launch control. Anybody foresee this causing issues?

Click to expand...

How did that work out for you? Any issues?

I was thinking of doing the same and just using heat shrink tubing to seal of the remaining connector end.

No issues.

Do you mind telling what ended up settling on for a tune?

I think I ran -3/+3 pretty much all of last season without any issues, but I was wondering if there are any stepped tunes people have tried or settled on as an alternative.