I
I plan on doing this and a question I have is;
When u put the gauge is diagnostic mode and toggle to water temp, the numbers u are seeing are not actual water temp numbers correct? They are just some kinda resistance or voltage type numbers and are off from what actual temp is.
So when the reflash is done, do u incorporate some sort of algorithm or change something to show actual temp or close to?
Also, I’m in your area from time to time for work. Do u have a drop box of some sort? What info should I leave with the gauge? Thanks
The numbers reported in diagnostic mode are not actually degrees. A reflashed gauge takes those numbers and subtracts a offset to get it a bit closer to degrees at operating temp.
As for dropping a gauge off to be reflashed, that is doable. There isn't a drop box, but there are cameras watching the packages area. Send an email or leave a message before dropping it off. Assuming you buy the reflash through the website, you just need to have the name with the gauge.