K
2016 axys with 2000 miles on motor. Before the turbo I was fighting rpms. So I went through the common motions while installing the turbo I put new motor mounts in then brought it to the dealer to check tps also asked them to check compression which I found out they never did. New belt all new clutching. Checked ves. Changed clutching all over. Anyway no luck on rpms. So I just rode at 8100 all year. So I did the tps myself and decided I better check compression. Mine is 92 per side at 1500ft. Checked my buddies new 18 and his is 120. Both sleds sitting side by side same gauge. So now that I am aware of this do i just put pistons in or do I do the shim kit and reliability from bikeman or ssi? Thanks sorry about the life story