SnoWest Snowmobile Forum - View Single Post - Re-Engineered REV Recoil Assembly
View Single Post
  #7  
Old 01-23-2017, 09:51 PM
shj shj is offline
Currently: Not set.
Join Date: Jan 2017
Basic Member
Age: 30
Posts: 12
Thanks: 1
Thanked 0 Times in 0 Posts
Rep Power: 0
shj is an unknown quantity at this point
Default

Originally Posted by shj
What do you mean by it's already being done?

rev recoil
Aluminum housing;
http://www.midwestproductionmachining.com/contact.html

Aluminum Pawl:
http://m.ebay.com/itm/192073811611?_mwBanner=1

Only 2 pieces that need to be aluminum. Frankly, just the pawl needs to be aluminum if some heat shielding is applied to the recoil housing. I have studied and repaired these things for years and it comes down to really being clean and using the proper lubricant. All that is maintenance. Obviously lower to no maintenance would be great. The aluminum pawl has eliminated failures. The second it starts to drag, it gets cleaned and lubed. Just my input.

Last edited by shj; 01-24-2017 at 04:56 AM.
Reply With Quote


Rate this post: Yes | No