PDA

View Full Version : Quick Stud ????


TKswild1
02-20-2008, 05:27 PM
I'm going to install the stud's that came with my bike. I have 56 shorties and 56 big one's for the tall stud... My ? is how many row's of stud's are there..?http://i21.ebayimg.com/02/i/000/db/2d/8a2f_1.JPG
will this pattern work with the amount off stud's I have 112

BlazinBya
02-20-2008, 06:48 PM
I have the same setup as the picture in mine and can say the only ones with wear are the center lugs,it seems the outsides never get the abuse at the center ones do,with 4per bar on half and 6 on the other half you would need 240,your short.I'd stud the center tall lugs with one stud per bar,alternating sides as you work around,then Id move to the intermediate lugs that have the first curved profile,staggering them opposite of the center bars,something similar to this...OR,just anty up and get the rest of the needed ones along with the template

These definetly help with keeping the track under the machine thru the trails,however it does stiffen the lugs up considerably(lil too stiff for deep POW)but they do work-

TKswild1
02-20-2008, 07:03 PM
Thank's Blazin 1 more for ya, did you pre drill the lug's for straightness or just bonzi drill, I'm afraid if I just drill-em they might peak out the side's of the lug. (mis-drill) that could be bad for the lug. Let me know thanks, Tom

BlazinBya
02-20-2008, 07:13 PM
Yep,I did predrill come to think of it,been a few years now but I recall using an 1/8 bit and getting a pilot hole for the screws to get started in,then an air ratchet,just so the base hits,it is possible to overtighten and twist the rubber lugs,you''ll find the right amount of torque once started.

TKswild1
02-20-2008, 07:48 PM
Thank's Jason, Can't wait till Mar.3-4 it's ON

barkatmon
02-21-2008, 12:26 AM
This PDF stud pattern show how to mount 112 studs, Year 2002 to 2006

http://www.klovsjo.com/skoter/hawk/Studmanuel2002-2006.pdf

http://www.klovsjo.com/skoter/hawk/112stud.jpg