W
2005 800 RMK Edge. This sled is in very good condition. I had Precision Products install a new crank in this sled in the fall of 2006. I only did it as a precaution. The motor and old crank were in excellent condition. I only put about 60 miles on the new crank last fall to make sure it was broke in and working before I had an accident that put me out of riding for the rest of the season. I have never seen an 800 that was not big bored out pull this sled.
The sled is located in Rigby Idaho. I am asking $5,000.00. You can contact me at 208-313-7220 or shunt2377@hotmail.com.
Precision porting (cases and cylinders)
Precision bored carbs
LW wrist pins
V-Force reeds
SLP head
SLP Twin race pipes
Race-Pac gauges w/EGT's welded into pipes
SLP Air Box kit
SLP motor torque arms
Attacc altitude compensator
Team LW 2ndary clutch
Fox shocks (front and rear)
Boss Seat
2 inch riser
R&M mesh hood
162 attack 20 (turned and drilled)
anti ratchet drivers
L.E.D. tail light
Holz Racing tie rods
The sled is located in Rigby Idaho. I am asking $5,000.00. You can contact me at 208-313-7220 or shunt2377@hotmail.com.
Precision porting (cases and cylinders)
Precision bored carbs
LW wrist pins
V-Force reeds
SLP head
SLP Twin race pipes
Race-Pac gauges w/EGT's welded into pipes
SLP Air Box kit
SLP motor torque arms
Attacc altitude compensator
Team LW 2ndary clutch
Fox shocks (front and rear)
Boss Seat
2 inch riser
R&M mesh hood
162 attack 20 (turned and drilled)
anti ratchet drivers
L.E.D. tail light
Holz Racing tie rods