Removing Secondary on M8

B

BroT

Free Member

Nov 26, 2007

224

5

18

Sedro-Woolley, WA

• Dec 3, 2007

• #1

M8 clutch torque specs

Is it loaded with spring tension or do i just loosen the bolt to remove it?

Any other cautions I should be aware of? I just want to take it off to clean it...

And...can someone give me the torque specs for both the primary and secondary?

 

Last edited: Dec 3, 2007

colorado_matt

Well-known member

Lifetime Membership

Nov 26, 2007

1,533

1,252

113

COLORADO

• Dec 3, 2007

• #2

Just take out the bolt and pull it off. It just rests on a splined shaft out of the diamond drive.

 

B

BroT

Free Member

Nov 26, 2007

224

5

18

Sedro-Woolley, WA

• Dec 3, 2007

• #3

Thanks...that's what I needed. Was afraid pieces would spring all over the garage.
T

 

N

Nubulin

Well-known member

Oct 26, 2005

848

206

43

Flatlands USA :(

• Dec 3, 2007

• #4

BroT said:

Thanks...that's what I needed. Was afraid pieces would spring all over the garage.
T

Click to expand...

Thats only on the early release 07 with the factory installed exploding clutch...........

 

B

BroT

Free Member

Nov 26, 2007

224

5

18

Sedro-Woolley, WA

• Dec 3, 2007

• #5

Nubulin said:

Thats only on the early release 07 with the factory installed exploding clutch...........

Click to expand...

what are the torque specs for that when reinstalling?

 

N

Nubulin

Well-known member

Oct 26, 2005

848

206

43

Flatlands USA :(

• Dec 3, 2007

• #6

Primary 55 ft-lbs
Secondary 32 ft-lbs

 

M

m7jino

Free Member

Nov 26, 2007

27

6

3

Calgary, AB

sledwest.blogspot.com

• Dec 4, 2007

• #7

If you are new to clutching these instructions at HCS will help you with removing the secondary:
http://www.hardcoresledder.com/forums/index.php?showtopic=269407