M
could i get a explanation on raising or lowering rpm on the doo?
new to doo clutching. a link would be great too
thx
new to doo clutching. a link would be great too
thx
clickers
- Thread starter mtn mike on boost
- Start date
There is a set of #'s 1-6 on the 3 bolts on the primary clutch. To raise or lower RPM on skidoo you need to loosen but not take off, ( do not take the nut all the way off or you could have the bolt fall out) then rotate the bolt. The lower the # the more it will pull down RPM. The higher the # the more rpm you will get.
Rotate all the bolts to matching #'s.
Rotate all the bolts to matching #'s.
R
D
Clickers
Talk to Rooster built, they'll set you up. Clicker up at higher elevations to maintain 8200 rpm. Each # should adjust around 200 rpm. Try to run on clicker 3-4 at optimal rpm, adjust pin weight to achieve this. Good luck
Talk to Rooster built, they'll set you up. Clicker up at higher elevations to maintain 8200 rpm. Each # should adjust around 200 rpm. Try to run on clicker 3-4 at optimal rpm, adjust pin weight to achieve this. Good luck
2
Anyone know what i should set them on for the Valemount are? I'm not sure of the elevation but i think its 3?
S
At elevation in valemount you will be around 6-7000ft. You will probably be at 3 or 4 on clickers. Use 1 when trail riding at low elevation.
Similar threads
