damn it all..<RANT>

B

brahm

Free Member

Dec 16, 2007

927

161

43

45

Mammoth Lakes, CA

www.pbase.com

• Oct 28, 2009

• #1

I was putting my rave valves back in and I dropped the cylinder part of the valve into the belly pan of my sled and the stupid thing won't roll to the front and it isn't magnetic so my magnetic arm can't nab it..

WHHHHHHHYYYYYYYYYYYYYYYYYYYYYYYY!

(end rant)
hahaha.

 

bgraff1

Well-known member

Lifetime Membership

Nov 29, 2007

894

323

63

Lloydminster, Alberta

• Oct 29, 2009

• #2

try lifting the rear of the sled up real high and it should roll to the front. a crane help lol

 

E

enis750

Well-known member

Nov 28, 2007

681

114

43

Area code 306

• Oct 29, 2009

• #3

that sux dude!! haha !

 

winter brew

Premium Member

Lifetime Membership

Nov 26, 2007

10,016

4,332

113

56

LakeTapps, Wa.

• Oct 29, 2009

• #4

Lay the sled on its side and swing a 20lb sledge as HARD AS YOU CAN against the belly pan. This will help.

 

B

brahm

Free Member

Dec 16, 2007

927

161

43

45

Mammoth Lakes, CA

www.pbase.com

• Oct 29, 2009

• #5

bgraff1 said:

try lifting the rear of the sled up real high and it should roll to the front. a crane help lol

Click to expand...

lol tried that, it's on the trailer lowred the front to the ground and lift the rear no luck.

winter brew said:

Lay the sled on its side and swing a 20lb sledge as HARD AS YOU CAN against the belly pan. This will help.

Click to expand...

That's next on my list need to get it off the trailer so I can tilt it over. Not sure I want to use a 20lb sledge as hard as I can won't that dent the pan.. haha.

 

B

BackCountryBob

Well-known member

Aug 7, 2001

928

158

43

Arvada, Colorado

• Oct 29, 2009

• #6

I just replaced my bent X bracket and found all kinds of stuff under there--take off the pipe and can and lay the sled over on the can side. BTW, pine cones do not qualify as "stuff"

BCB