Code 81 ? Nytro mtx

T

Trentikles

Free Member

Dec 1, 2007

51

1

8

• Dec 26, 2008

• #1

Trouble with the key switch. Wiggle the connection to get pwer to the gauge's, and then when you turn the key to start the sled, the power to the gauge's quits. We were in some very deep powder so i think there is just some moisture in the connection, but the engine light came on and i don't know if this is related.
Any help would be appreciated.

 

jrusher

Well-known member

Lifetime Membership

Dec 1, 2007

498

285

63

Edmonton

• Dec 26, 2008

• #2

Code 81 I believe is the Handwarmers.. I'll have to chack my service manual to confirm..

 

skidooboy

Well-known member

Lifetime Membership

Nov 26, 2007

1,660

330

83

central lower michigan

• Dec 26, 2008

• #3

grip warmer code. you have a short in the hand grip warmer. either in the element itself (more than likely), or the wiring is chafed. sometimes the grips being held tightly spin alittle while riding causing the element wrap to fail, grounding the wires in the heater. ski

 

T

Trentikles

Free Member

Dec 1, 2007

51

1

8

• Dec 26, 2008

• #4

Thanks. I will check out the routing and condition of the wires.

 

J

johnny be bad

Well-known member

Nov 26, 2007

11,936

1,065

113

in the getto

• Dec 26, 2008

• #5

15 - Throttle Position Sensor and Circuit problem
16 - Throttle Position Sensor stuck
21 - Coolant Temperature Sensor and Circuit
42 - Speed Sensor
46 - Power Source Voltage
80 - Grip Warmer Switch and Circuit
81 - Grip Warmer and Circuit
82 - Thumb Warmer Switch and Circuit
83 - Thumb Warmer and Circuit
84 - TORS System Activated(throttle override)
86 - Cold Engine Protection Activated


hope this helps some of you!