I have a 09 M8 Sno Pro that has become a backup sled over the years.
I have noticed that I have an intermittent connection in the main wiring
harness that feeds into the ECM. This cuts out one cylinder until i move
harness and get it to make contact again. Trying to find a bad wire that is intermittent is not my cup of tea!
It may run fine for 10 miles then decide to loose contact. Get it to run
and may run again for any unspecified time.
I have been told that there was a problem with the main harness in 09.
My question is has any one else ran into this problem or am i one of the
few ? A New Harness is very expensive to guess on.
If you have any helpful information I would appreciate it. Thanks RickM
I have noticed that I have an intermittent connection in the main wiring
harness that feeds into the ECM. This cuts out one cylinder until i move
harness and get it to make contact again. Trying to find a bad wire that is intermittent is not my cup of tea!
It may run fine for 10 miles then decide to loose contact. Get it to run
and may run again for any unspecified time.
I have been told that there was a problem with the main harness in 09.
My question is has any one else ran into this problem or am i one of the
few ? A New Harness is very expensive to guess on.
If you have any helpful information I would appreciate it. Thanks RickM