QRS Bearing rmeoval

I made my own press...wasn't too difficult to make, but lasered it out and used ready rod to pull. Used it more than a handful of times and has worked pretty good. Drawings attached for reference. The third plate in that drawing set I cut to use as a press to get the bearing back on, but haven't used it much. Usually just tapping around the bearing with a deadblow hammer has worked out fine.

If it helps you out, I made a spare one when I cut the first one a few years back that I could part with? Just the plates..you'd need nuts and ready rod.

Cheers
RK

Bring the shaft to a dealer and have them pop it off quick!