S
Just installed the 5 foot auxiliary cooler from mtntk and very pleased with the fit and finish of the cooler. Easy install. Just need snow to see the new temps.
MTNTK auxiliary cooler
- Thread starter seanrohatyn
- Start date
S
Not sure why the pics rotated. Lol
This makes me excited to get mine installed. I picked one up at Haydays and just haven't put it in yet.
Any tips or tricks for install that I should know or was pretty much just by their instructions?
Any tips or tricks for install that I should know or was pretty much just by their instructions?
S
I just followed the instructions minus removing the drivers. It's pretty straightforward.
We just did 3 of them on our Axys Turbos. We measured and marked where the outside edges of the cooler should be located to get it perfectly in the center. 3 sets of hands can have it installed in 45 minutes start to finish.
M
I've been wondering if the install could be done without removing the track and driveshaft, that answers that question.
S
Yep. More than enough room with the track and driveshaft still in. It's way easier to hang the rear of the sled from the roof than laying it on the side.
T
I did Moosesp's extra heat exchanger at a length of 24" and I run about 107 degrees in the powder and about 114 degrees on the trail with factory scratchers.
S
Finally got out to test it. Air temp was -24*C with hard pack drifts no scratchers down. Some ditch banging and playing in sloughs. Never climbed over 127*F. A great investment on this machine.
0
coller
well after reading this I ordered one for the wife's sled. hope it helps
well after reading this I ordered one for the wife's sled. hope it helps
S
The only major drawback I see is that I'm the last to join the group since I have longer warm up time.
