How do you get to the reeds in the middle? Can't figure out how to get it apart! 
How to put new reed petals on stock assembly? Help!
- Thread starter WYsteph
- Start date
A
The metal divider holds the inner petals in place. You have to remove the two screws on the intake side of the cage and the give the metal divider a good yank pulling it straight out. I found I had to grab the metal center divider with a pair of pliers, try not to scuff it up, if you do sand out the scuffs.
Thanks, that helped.
I ended up using 2 drill bits in the hold down holes and tapped them out.
I ended up using 2 drill bits in the hold down holes and tapped them out.
I believe Boysen makes a replacement set:
http://boyesenc.nexcess.net/wordpress/wp-content/uploads/2011/09/F_Snow_Apps_2012.pdf
800 800 (CFI) 08-12 2 49.95 570SF1
http://boyesenc.nexcess.net/wordpress/wp-content/uploads/2011/09/F_Snow_Apps_2012.pdf
800 800 (CFI) 08-12 2 49.95 570SF1
