PDA

View Full Version : 700sx psi pipes to 600sx


miikkeli
09-15-2013, 05:59 AM
can i put a 700sx psi triple pipes to 600sx. is there any problems?
and how about jetting on 0ft and 0C temperature.

Anylizer
09-16-2013, 04:24 PM
I know of a few guys who went the other way... 600 pipes on the 700. this was done for use at higher elevations. I cannot comment on the jetting specs, but I would think that they would run, although maybe not ideal.
IIRC, there was a slight difference in the initial diameter/taper of the header & diffuser cone.
When used on the 700, the 600 pipes seemed to have increased throttle response.

miikkeli
09-17-2013, 11:39 AM
I also thought it should work, because the stock in both have the same pipe 600 & 700. If somebody have experience of that, please let me know.

TRIPLESWILLNEVERDIE!
10-16-2013, 05:52 PM
I have tried a few sets of 700 pipes on the 600. Bender, SLP, Aaen. All had throttle response issues. I spent a lot of hours jetting and never got it right. Ended up running the stock single with Bender race can and had better performance than I did with the triples.
If you try the psi 700 pipes you may have to weld in some reducer rings into the stinger outlets.

miikkeli
10-19-2013, 11:38 AM
but in the slp home site, seems to be same production number on both pipes, 600sx and 700 sx. feels like they should atleast work on 600.

TRIPLESWILLNEVERDIE!
10-20-2013, 01:34 PM
Yea, I don't think slp made a specific set of triples for the 600. They are just the same as the 700 pipes.
Bender made a specific set for the 600. The stinger diameter was smaller than the 700 pipes. expansion chamber size was the same.

Rx1Mountain
12-25-2013, 07:28 PM
Do you have a set of PSI's for a 700? If so, I'd be interested in them. Thanks.