PDA

View Full Version : 2.4 inch track in 2002 rmk???


NINJIN
12-01-2009, 12:14 PM
will a 2002 edge rmk clear a 2.4 inch track without drop and roll or smaller drivers??
thanks

theultrarider
12-01-2009, 12:36 PM
I reallky doubt it. I just put a 2.5 camox under mine last weekend with 7tooth 3.0 drivers. They are 1/2 small dia than stock. Without those, I don't see it going in there. 2.25 is about max with no mods

ullose272
12-01-2009, 12:37 PM
i dont think so, i believe 2 1/8 is biggest.

skibreeze
12-01-2009, 12:40 PM
If you ever look at the front part of the tunnel, you will see where the stock 2" lugs have rubbed. You will definitely need a D&R or smaller drivers.

Tree_Killer
12-01-2009, 12:58 PM
nope, it wont fit. 2" is about the max. 2" 1/8 might fit with just a little rubbing.

the_dougdangerak
12-01-2009, 01:47 PM
I ran a 2.25 finger for 3 years and that was with stock drivers. Yes it rubbed, but I run my track good and tight, the way its supposed to be. This was on a 02' 800, no D&R.

sled_guy
12-01-2009, 05:10 PM
Are you talking about the Polaris Series IV 2.4? If so, no it won't fit.

sled_guy

Snowlover
12-01-2009, 05:56 PM
2.125 is max. Mine clears, but there are marks on the top of the tunnel where it has hit on occasion.

Stock 02 with series iv 159x2.125

rmkboxer
12-01-2009, 08:36 PM
you will need to get a holz drop kit for the chaincase or some one elses d&r kit, I had one on mine but I had the drop kit from holz. I personally didn't like the track, the 2 1/8 I thought worked better for out conditions here anyway

this1ultraflyz
12-02-2009, 12:57 AM
Avid makes a very sweet chain case. Drives me crazy knowing its available.

NINJIN
12-02-2009, 07:18 AM
will a vanamburg 5/8 down drop and roll kit give clearance? i would assume that would get enough room in there???
thanks for all the replies
probably could have just went and looked and found out for myself....

Treesfearme
12-02-2009, 08:08 AM
i have been running a 2.25 chalenger for 3 years with no issues. It is the biggest you can fit stock. It does rub on the top of the tunnel but not on the front cooler

Chris

rmkboxer
12-02-2009, 09:04 AM
will a vanamburg 5/8 down drop and roll kit give clearance? i would assume that would get enough room in there???
thanks for all the replies
probably could have just went and looked and found out for myself....

yes it will work then

John Wayne
12-04-2009, 07:29 AM
I have two 02 RMK's with 2.4 polaris tracks in them. I removed 3/16" from the drivers on a lathe. It was real tight to install over the drive cogs. I've been running them now for 5 years with no clearance problems. I would do it again in a heartbeat.